Product added to cart
Hepa 500 Filter, 16 In. W, 19 In. H
$320.00
In stock
Only 2 left
SKU
AF0321 2 PAK
HEPA F321 filter 16" X 19" X 2.5" for Dri-Eaz air scrubber is 99.97% efficient at removing particulates including smoke, dust, and other airborne viral contamination.
These HEPA filters (F321) are the primary filters used in the Dri-Eaz DefendAir HEPA 500 Air Scrubber. These filters combine a powerful filtration ability with a remarkable filtration capacity.
HEPA filter for DRI-EAZ air scrubber is 99.97% efficient at removing particulates including smoke, dust, and other airborne viral contamination.
Technical Specifications
- Item: HEPA Filter
- Nominal Filter Size: 16x19x2-1/2
- Nominal Height: 19
- Nominal Width: 16
- Nominal Depth: 2-1/2
- Frame Included: Yes
| Brand | Dri-Eaz |
|---|---|
| Dimensions | 16" X 19" X 2.5" |
| Air Filter Type | Hepa 500 Filter |
| Air Filter Usage | For Dri-Eaz DefendAir HEPA 500 Air Scrubber |
Remediation Applications
- Wear NIOSH-approved protective gear when changing filters.
- Change filters after every remediation job.
- Change HEPA filter when the filter indicator light comes on.
- Dispose of used filters according to local regulations.
- Replace both the prefilters and HEPA filter to prevent cross contamination.
- Clean the unit thoroughly (vacuum and damp wipe per IICRC S520, 10.11) after each job before removing it from the containment area to avoid cross-contamination. Pay particular attention to the area around the air intake. Let the unit dry before installing clean filters.
Filter access instructions
To change the HEPA filter, lay the unit flat on its back, then use a 3/8 in. wrench to loosen the 8 retaining tab nuts holding the inlet panel in place. Slide the retaining tabs outward, away from the center of the inlet panel, and lift off the inlet panel. Lift out the used HEPA filter and replace it with a new one. Do not clean and reuse the HEPA filter. After making sure that the filter is properly seated, replace the inlet panel, slide the tabs back into place, and tighten the nuts. Do not overtighten. The HEPA 500 is now ready to return to service.
Write Your Own Review